HEIDENHAIN iTNC 530 HSCI - Page 443

27 – 444 HEIDENHAIN Service Manual iTNC 530 HSCI
Machine
operating panel
HSCI adapter
for PLB 6001
OEM-specific
machine operating
panel
TE 635Q
NC control panel:
Same features as TE 630
Machine operating panel:
 15-inch design
 6 axis-direction keys
 16 function keys
 Keys for NC start and NC stop (illuminated)
 Keys for spindle start and spindle stop
 All keys in the machine operating panel are snap-on keys.
 EMERGENCY STOP key
 Key for control voltage ON (RAFI key, illuminated)
 Two bore holes (22 mm) for additional RAFI buttons
(shipped blocked with a cover) or detachable key switches
 HSCI interface
 Fulfills IP54 degree of protection when installed
MB 620
The MB 620 is equipped with:
 15-inch design
 HSCI interface
 Handwheel connection X23
 21 snap-on (exchangeable) keys
The key functions are freely definable via the PLC.
 8 PLC inputs and 8 PLC outputs
 Two bore holes for additional keys or keylock switches
 Fulfills IP54 degree of protection when installed
PLB 6001
The PLB 6001 is equipped with:
 HSCI interface
 Handwheel connection X23
 64 PLC inputs, 32 PLC outputs for keys / key illumination
 Connection for spindle-speed and feed-rate override
potentiometer
 Screw fastening or top-hat-rail mounting