February 2012 27 – 445
Handwheels
HR 410
Portable electronic handwheel with snap-on (exchangeable)
keys.
Five axis selection keys
Keys for traverse direction
Keys for preset feeds
Actual-position-capture key
Three keys for machine functions
(definable via PLC)
• Spindle right/left/stop
• NC start/stop, spindle start;
for HEIDENHAIN basic PLC program
Two permissive buttons (24 V)
Emergency stop button (24 V)
Magnetic holding pads
HR 520
Portable electronic handwheel with snap-on (exchangeable)
keys.
Display for operating mode, actual position value,
programmed feed rate and spindle speed, error messages
Graphic display;
resolution: 128 x 64 pixels, 6-line display
Spindle speed and feed-rate override
Selection of axes via keys or soft keys
Actual position capture
NC start/stop, spindle start/stop
6 freely programmable PLC keys with LED
Keys for traverse direction
Exchangeable snap-on keys for PLC functions and
maintenance
Integrated permissive key and emergency stop button
(24 V)
Magnetic holding pads
Mount for attaching the handwheel to the machine
HR 130
Panel-mounted handwheel With ergonomic knob
Radial cable outlet
With or without detent
To Next Page
Loading...
