February 2012 27 – 447
TS 220
Triggering touch probe with signal transmission over cable
connection for machines with manual tool change; for
workpiece setup and measurement during machining
TS 220
Adapter cable for connection
to the system PL or the UEC
TT 140
Tool touch probe
Touch trigger probe with rated break point of the connection
pin for the probe head and optical deflection display. An
additional connection pin is delivered with the touch probe.
TT 140
Connection pin
Adapter cable for connection
to the PL 62xx
TT 449
Tool touch probe
Touch trigger probe with rated break point of the connection
pin for the probe head and optical deflection display. An
additional connection pin is delivered with the touch probe.
The TT 449 is wireless and communicates over infrared beam
with the SE 642.
TT 449
Connection pin
To Next Page
Loading...
