29 – 518 HEIDENHAIN Service Manual iTNC 530 HSCI
Feature Content
Level
When a new NC software version is released, error fixes and improvements in functions are managed
separately.
When the NC software is updated to a new version, only the included error fixes will initially be
effective.
If the new features of this NC software version are also required, these can be ordered and
subsequently be enabled with a code number. --> Ask the machine manufacturer!
The Feature Content Level is now numbered consecutively:
The Feature Content Level is shown in the code number window. --> See ”Display of important
system information” on page 27 – 451.
The Feature Content Level is also displayed in the SIK window (see previous illustration).
A higher Feature Content Level always includes the features of the previous versions.
Electronic ID label Some HEIDENHAIN units feature an electronic ID label.
The product name, the ID number and the serial number are saved in this ID label.
Prerequisite for the evaluation of the electronic ID labels of the iTNC 530 HSCI:
Under these conditions, the devices are automatically detected when the control is started.
During every control restart, the control checks whether the connected units with electronic ID label
match the entries in MP2100.x or MP2200.x.
Machine parameters Current units with electronic ID label
MP7690 is active HEIDENHAIN inverters with "D" in the device name, e.g., UM 112D
HEIDENHAIN synchronous motors with EnDat motor encoders
To Next Page
Loading...
