February 2012 29 – 517
SIK
The SIK (= System Identification Key) ...
is located in a slot on the side of the MC 6222 housing (slot X125).
is located in a slot on the bottom of the MC 6241 housing (slot X125).
contains the NC software license (standard or export version).
stores enabled control loops and software options (e.g, tilting operation, HSC milling, TCPM,
cylindrical surface interpolation, synchronized axes, etc.)
contains the Feature Content Level (of the NC software version).
is inserted in the replacement control, if the control needs to be exchanged.
--> Thus all enabled options are still available!
After you have entered the code word SIK, the SIK number and the enabled options are displayed on
the screen.
The SIK number is also printed on the ID label applied onto the board of the SIK.
To Next Page
Loading...
