February 2012 29 – 529
8 Accept these changes. --> The control will start up completely and display the following message
(press the HELP key for this purpose):
8 Acknowledge the message.
8 Call the log. --> See ”Log” on page 8 – 79.
8 Search for the string HWSDialog in the log.
8 Here you can see which new HSCI devices were found and which firmware was updated.
(In the example: the machine operating panel MOP)
8 Press SEARCH and EXECUTE until all updated HSCI devices are listed.
8 Switch on the machine and test the functions.
If you find the message Exchange the peripheral device in the log, or a similar message
indicating that the firmware of older HSCI devices could not be updated
--> Contact your OEM or a HEIDENHAIN service agency!
To Next Page
Loading...
