February 2012 29 – 533
Restoring the
original state of
the machine
If necessary, you may ...
recalibrate the touch probes.
initialize the swivel head again.
initialize the tool changer again.
Contact the machine manufacturer for information!
Functional test
8 Check the machine functions (with the aid of the machine operator).
Returning the
defective MC 6222
8 Replacement controls are delivered with a form which you can use to provide information on the
error of the defective control.
Please fill in this form and attach it to the housing of the MC 6222.
8 Use the original packaging of the new MC 6222 to package the defective MC 6222.
8 Return the defective MC 6222 to the machine manufacturer or to your HEIDENHAIN service agency.
On machines with analog axes, an offset fine adjustment should be performed with the
HEIDENHAIN code number after the control was exchanged.
--> See ”Adjusting the electrical offset (drift adjustment)” on page 21 – 355.
To Next Page
Loading...
