HEIDENHAIN iTNC 530 HSCI - The machine parameter editor

February 2012 31 – 573
Calling the
machine parameter
editor
8 Select the Programming and Editing operating mode.
8 If open: Close the program management by pressing the END button.
8 Call the code number window.
8 Enter the code number and press ENT to confirm.
The active machine parameter list appears on the screen in the Machine Parameter Programming
mode:
8 Press the END key to exit the machine parameter mode list.
Note
Pressing the MOD key while the program manager is open calls screen where you can make the
interface settings.
Note
If the message Line is write-protected is displayed when you try to edit a machine-parameter
value, individual machine parameters or the entire MP list is protected against editing.
The machine manufacturer has defined his own MP code number. --> Please contact your
machine manufacturer!