HEIDENHAIN iTNC 530 HSCI - Page 573

31 – 574 HEIDENHAIN Service Manual iTNC 530 HSCI
Input format MP values can be shown in different formats:
 Decimal:
There is no identifier before the value.
Example: MP910.0 : +1000 ; traverse range
 Binary:
The identifier % is displayed before the value.
Binary input is recommended for machine parameters that activate individual functions bit-encoded.
Example: MP10 : %00000000011111 ; active axes
 Hexadecimal:
The identifier $ is displayed before the value.
The hexadecimal input is suitable, e.g. for large numerical values.
Example: MP7350 : $0808080 ; color mixture in red-green-blue for the window frame
For MP1054.x (linear distance of one motor revolution) and MP7530.x (type of dimension for
transformation) also a formula may be indicated instead of a fixed value.
Comments on
the MPs
See “Meaning of the machine parameters” on page 31 – 579.
Creating a copy of
the original MP file
If changes to the machine parameters are required for for servicing (troubleshooting, testing), these
should not be made in the original MP list!
Create a copy of the original MP file and activate this copy.
8 Call the active machine parameter list (see previous page).
8 Call the program management.
8 The cursor automatically is on the active machine parameter file (status M).
If not, place the cursor on the active file.
8 Press this soft key.
8 Enter the name of the working copy in the header, e.g., TEST.MP.
8 Press this soft key or the OK soft key (or the ENTER
key) to start copying.
8 The copy is created. It is stored in the same directory as the original MP file.
Note
You can also protect the original MP file against editing or overwriting --> soft keys MORE
FUNCTIONS / PROTECT.
The letter P (for "protected") is displayed in the status column of the program management.
Of course, you can also back up important data on an external data medium beforeyou start
servicing!