HEIDENHAIN iTNC 530 HSCI - Page 602

February 2012 31 – 603
MP3143 Mounting configuration of the spindle position encoder
Input: 0: Position encoder directly on the first spindle
1: Position encoder via transmission (ratio in MP3450.x and MP3451.x);
X30 pin 1: reference pulse
2: Position encoder via transmission (ratio in MP3450 and MP3451); X30
pin 1: reference pulse release
3: Same as input value 1, except that the second reference pulse is
evaluated.
4: Reference-mark evaluation of the spindle via EnDat. The encoder
must be mounted directly (without transmission). No reference pulse
is necessary. A new reference-mark evaluation via marker M4015
may only be performed at standstill.
5: The position encoder is mounted directly (same as input value 0) and
the transmission ratio is also evaluated. (rigid tapping will also be
possible without a spindle position encoder!)
PLC
RUN
MP3210.0-7 Analog nominal spindle voltage at rated speed for the gear ranges 1 to 8
Input: 0 to 100.000 [V]
Digital spindle motor revolutions at rated speed for the gear ranges 1 to 8
Input: 0 to 100.000 [1000 min
–1
]
PLC
RUN
MP3240.1 Analog spindle: Minimum nominal value voltage
Input: 0 to 9.999 [V]
Digital spindle: Minimum motor speed
Input: 0 to 9.999 [1000 min
–1
]
PLC
RUN
MP3240.2 Analog spindle: Spindle jog voltage for gear shifting (M4009/M4010)
Input: 0 to 9.999 [V]
Digital spindle: Motor speed for gear shifting (M4009/M4010)
Input: 0 to 9.999 [1000 min
–1
]
MP3310 Limitation for spindle speed override
Input: 0 to 150 [%]
PLC
RUN
MP3310.0 Upper limit
MP3310.1 Lower limit
MP3350 Maximum permissible overshoot of the spindle speed in percent of the nominal spindle
speed
Input: 0 to 100 [%]
PLC
RUN
MP3351 Entry of an absolute value for the permissible overshoot of the spindle speed
Input: 0.001 to 100000.000 [rpm]
0 = Monitoring off
PLC
RUN
MP3411.0-7 Ramp gradient of the spindle with M03 and M04 for gear ranges 1 to 8
Input: Analog axes: 0 to 1.999 [V/ms]
Digital axes: 0 to 1.999 [1000 min
–1
/ms]
PLC
RUN
MP3412 Multiplication factor for MP3411.x
Input: 0.000 to 1.999
PLC
RUN
MP3412.0 With M05
MP3412.1 With oriented spindle stop
MP3412.2 With tapping with floating tap holder
MP3412.3 With rigid tapping
MP3415 Overshoot behavior of the spindle with M03, M04 and M05
Input: 0 to 1000 [ms]
PLC
RUN
MP3415.0 With M03, M04 and M05
MP3415.1 For oriented spindle stop
MP3415.2 With tapping
MP3415.3 With rigid tapping
MP Function and input Software
version and
behavior