HEIDENHAIN iTNC 530 HSCI - Page 612

February 2012 31 – 613
MP6570 Max. permissible surface cutting speed at the tooth edge
Input: 1.0000 to 129.0000 [m/min]
PLC
RUN
CN123
MP6572 Maximum permissible speed during tool measurement
Input: 1 to 1000 [min
–1
]
0: 1000 [min
–1
]
PLC
RUN
CN123
MP6580.0-2 Coordinates of the TT 130 probe contact center with respect to the machine datum
(traverse range 1)
Input: –99 999.9999 to +99 999.9999 [mm]
PLC
RUN
CN123
MP6581.0-2 Coordinates of the TT 130 probe contact center with respect to the machine datum
(traverse range 2)
Input: –99 999.9999 to +99 999.9999 [mm]
PLC
RUN
CN123
MP6582.0-2 Coordinates of the TT 130 probe contact center with respect to the machine datum
(traverse range 3)
Input: –99 999.9999 to +99 999.9999 [mm]
PLC
RUN
CN123
MP6585 Monitoring the position of the rotary and additional linear axes during the tool
measurement cycles
Format: %xxxxxx
Input: 0: Axis is not monitored
1: Axis is monitored
Bit 0 – A axis
Bit 1 – B axis
Bit 2 – C axis
Bit 3 – U axis
Bit 4 – V axis
Bit 5 – W axis
PLC
RUN
CN123
MP6586 Ref. coordinate for monitoring the position of the rotary and additional linear axes during
the tool measurement cycles
Input: –99 999.9999 to +99 999.9999 [mm or °]
PLC
RUN
CN123
MP6586.0 A axis
MP6586.1 B axis
MP6586.2 C axis
MP6586.3 U axis
MP6586.4 V axis
MP6586.5 W axis
MP6600 KinematicsOpt: Maximum permitted change value
Input: 0.010 to 1.000 [mm]
PLC
RUN
CN123
MP6601 KinematicsOpt: Radius deviation of the calibration sphere
Input: 0.010 to 0.100 [mm]
PLC
RUN
CN123
MP6602 KinematicsOpt: M-function macro for positioning the rotary axes
Input: 0 to 999
-1: Function inactive
PLC
RUN
CN123
MP Function and input Software
version and
behavior