HEIDENHAIN iTNC 530 HSCI - Page 629

31 – 630 HEIDENHAIN Service Manual iTNC 530 HSCI
MP7502 Functionality of M144/M145
Input: %xxx
Bit 0 –
0: M144/M145 not active
1: M144/M145 active
Bit 1 – M144/M145 in the automatic modes
0: M144/M145 active
1: M144 is activated automatically at the start of an NC program. It can
only be deactivated with M145 during an NC program.
Bit 2 – M144/M145 in the manual modes
0: M144/M145 not active
1: M144/M145 active
PLC
RUN
MP7503 Virtual tool axis – Reapproaching the contour and manual traverse in the current tool-axis
direction (FCL2 upgrade function)
Input: 0: Inactive
1: Active
PLC
RUN
MP7506 Selection of kinematics at booting of the control
Input: 0 to 999
-1: Function inactive
PLC
RUN
MP7507 Selecting the kinematics for the operating mode
Input: %xxx
Bit 0
0: Kinematics cannot be selected in Editing operating modes
1: Kinematics can be selected in Editing operating modes for simulation
in Test Run mode
Bit 1
0: Kinematics cannot be selected in Program Run operating modes
1: Kinematics of the real machine can be selected in Program Run
operating modes
Bit 2
0: 3D ROT soft key is not available in Test Run mode
1: 3D ROT soft key is available in Test Run mode
PLC
RUN
MP7510
(only possible
via the old
kinematics
table)
Reserved
MP7520
(only possible
via the old
kinematics
table)
Reserved
MP7530
(only possible
via the old
kinematics
table)
Reserved
MP7550
(only possible
via the old
kinematics
table)
Reserved
MP Function and input Software
version and
behavior