Date/Time: Click on the need to modify the location, pop-up keyboard,
enter the date and time through the keyboard.
Record Mode: For "Overwrite", when the disk is full, it will
automatically overwrite the oldest video; when the disk is not full, but
the number of video days reaches the user setting, the oldest video will
be automatically overwritten.
Record Days: Set the number of days for NVR recording storage. There
are no Limit, 30, 15, 7, 6, 5, 4, 3, 2, 1 options in the drop-down menu.
Auto Log Out: The default is 10 minutes, can be set range: 1 Minute, 2
Minutes, 5 Minutes, 10 Minutes, 20 Minutes, 30 Minutes, 60 Minutes
and Never, where "Never" for the permanent standby.
Device Name: Fill in the name of the device according to actual needs,
the default is NVR.
Mouse Pointer Speed: Set the mouse movement speed, the larger the
value, the faster the mouse response, and the smaller the value, the
slower the mouse response, you can set 0-5.
Enable Wizard: Click the " ", open the startup wizards, and then
directly enter the "Startup Wizard" interface each time you boot.
Date Format: Select the date display format, including "Day Month
Year", "Month Day Year" and "Year Month Day".
Time Format: Choose a 24-Hour or 12-Hour format.
Separator: Select the separator for the date format.
Enable DST: Check " ", open the daylight saving time function, set the
relevant parameters, such as Type, Date, Start Time, End Time and so
on.
Type: Daylight saving time setting.
Start Time: The start time for daylight saving time
End Time: The end time for daylight saving time
Offset(min): The offset time for daylight saving time
Channel Check Time: Select the channel whose time needs to be
checked, set the update interval, and click "Save" to set the channel
time to be consistent with the NVR time.
Steps 3: Click "Apply" to save the setting.
5.3.7.2 TCP/IP
Network is composed of TCP/IP, Address Filter, Cloud Storage and Advanced.
To Next Page
Loading...