37. Install the Drive Assembly.
a) Ensure that the enclosure has been pulled out of the rack until the rail latches engage.
b) Find the LED pointer on the top of the drive carrier. This pointer should point toward the front of the
unit as shown in the following image.
Figure 150: LED Pointer Orientation
c) Align the drive with the empty slot that will receive it. Lower it into the slot, making sure it stays level
and does not snag.
Figure 151: Installing a Drive Assembly
d) Pinch the latch release and carefully press downward to seat the Drive Assembly the rest of the way.
38. Install each drive in the place it was removed from by following the labels or marks that were added
earlier.
39. If the chassis is being installed into a rack that will be shipped fully assembled, you must install eight
(four per side) of the included M5 x 10mm T15 Torx screws into the two brackets at the front of the chassis
in the following locations. These screws should be tightened to 3.38-3.61 Nm / 30-32 in-lbf using a Long
131
4 Part Replacement
User Guide 4.9 Chassis Replacement
To Next Page
Loading...
Need help?
General
