HIKVISION AXHub - Page 43

Figure 4-26 Add User Page
5.
Set the keypad password (numeric, 4~8 characters).
6.
Check the check boxes to set the user permission.
The user can only operate the assigned permissions.
7.
Click OK.
8.
Oponal: Enable the user in the Enable User column to allow
the enabled user
operang the device.
9.
Oponal: Select an user and click Edit and you can edit the
user's informaon and permission.
10.
Oponal: Delete a single user or check mulple users and
click Delete to delete users in batch.
Note
The admin and the seer cannot be deleted.
Add/Edit/Delete Keyfob
You can add keyfob to the security control panel and you can
control the security control panel via the keyfob. You can also edit
the keyfob
informaon or delete the keyfob from the security
control panel.
Steps
1.
Click User Management → Keyfob to enter the Keyfob
Management page.
Figure 4-27 Keyfob Management
2.
Click Add and press any key on the keyfob.
3.
Set the keyfob parameters.
Name
Customize a name for the keyfob.
Permission
Sengs
35