HIKVISION AXHub User Manual

Access level of Arming
The user in level 2 or 3 has the permission to arm or partly arm
the system.
Arming Indicaon
The arming/disaring indicator keeps solid blue for 5s.
Reason of Arming Failure
•
Intrusion detector triggered (excepts the detector on the exit
route).
•
Panic alarm device triggered.
•
Tampering alarm occurred.
•
Communicaon excepon
•
Mian power supply excepon
•
Backup baery excepon
•
Alarm receiving fault
•
Siren fault
•
Low
baery of the keyfob
•
Others
Arming with Fault
While the arming is stopped with fault, user in level 2 has the
permission to arm the system with fault (forced arming).
Fored arming only taks eect on the current arming operaon.
The forced arming operaon will be record in the event log.
5.2 Disarming
You can disarm the system with keypad, keyfob, card, client
soware, or mobile client.
Disarming Indicaon
The arming/disarming indicator ashes 30s while the user
successfully disarm the system through the entry/exit route.
The system will report the disarming result
aer the operaon
completed.
Entry Delay
Duraon
Ensure that mer is no longer than 45 seconds in order to comply
with EN50131-1.
Early Alarm
If either the intrusion or tampering alarm occurs on the enter/exit
route when the control panel is in the status of entry delay, the
control panel then enters the early alarm mode.
The early alarm
duraon can be set (> 30s).
The control panel will reports the alarm only if the alarm event
lasts over the duraon of early alarm with the addion of entry
delay.
54

HIKVISION AXHub Specifications

General

Brand	HIKVISION
Model	AXHub
Category	Control Panel
Language	English