HIKVISION AXHub User Manual

A.2 Mutual Exclusion of Funcons
A.2.1 Unable to Enter Registraon Mode
Fault Descripon:
Click the panel funcon key, and prompt key invalid.
Soluon:
The panel is in "AP" mode. Switch the panel to "staon" mode,
and then try to enter the registraon mode again.
A.2.2 Unable to Enter RF Signal Query Mode
Fault Descripon:
Double-click the host funcon key, and the prompt buon invalid.
Soluon:
The panel is in "AP" mode. Soluon: switch the panel to "staon"
mode, and then try to enter the RF signal query mode again.
A.3 Zone Fault
A.3.1 Zone is Oine
Fault Descripon:
View status of zones which displays oine.
Soluon:
Check whether the detector reports undervoltage. Replace the
detector
baery
A.3.2 Zone Tamper-proof
Fault Descripon:
View status of zones which displays tamper-proof.
Soluon:
Make tamper-proof buon of the detector holden.
A.3.3 Zone Triggered/Fault
Fault Descripon:
View status of zones which displays triggered/fault.
Soluon:
Reset the detector.
A.4 Problems While Arming
A.4.1 Failure in Arming (When the Arming Process
is Not Started)
Fault Descripon:
When the panel is arming, prompt arming fails.
Soluon:
The panel does not enable "forced arming", and when there is a
fault in the zone, the arming will fail. Please turn on the "forced
arming" enable, or restore the zone to the normal status.
A.5 Operaonal Failure
A.5.1 Failed to Enter the Test Mode
Fault Descripon:
Failed to enable test mode, prompng "A fault in the zone".
Soluon:
63

HIKVISION AXHub Specifications

General

Brand	HIKVISION
Model	AXHub
Category	Control Panel
Language	English