HIKVISION AXHub User Manual

Entry Delay 2
Set a value for Entry Delay 1 and Entry Delay2. Entry delay is a
me concept. If entry delay is congured for the delayed zone,
when you enter an armed delayed zone, the zone alarm will
not be triggered
unl the end of entry delay.
Note
Aer set value for Entry Delay 1 and Entry Delay 2, you should
set the entry delay of a specic zone to the value of Entry
Delay 1 or Entry Delay 2.
Exit Delay
Set exit delay for the delayed zone. If exit delay is
congured
for the delayed zone, aer you arm the zone on the indoor
unit, you can exit the zone without triggering alarm unl the
end of exit delay.
Siren Delay Time (Perimeter Alarm)
The
duraon that the siren lasts when perimeter alarm is
triggered.
Note
For details about perimeter alarm, see the user manual of the
security control panel.
4.4.11 Check System Status (Zone Status/
Communicaon Status)
You can view the zone status and the communicaon status via
the mobile client.
View Zone Status
In the Paron page, tap Zone to enter the Zone tab. You can
view the each zone's status in the list.
Communicaon
Mode
In the Paron page, tap → Device Informaon to enter the
page. You can view the device
communicaon status, including
the baery, Ethernet network, Wi-Fi, mobile network, data usage
and so on.
4.4.12 Check Alarm
Nocaon
When an alarm is triggered, and you will receive an alarm
nocaon. You can check the alarm informaon from the
mobile client.
Before You Start
•
Make sure you have linked a zone with a detector.
•
Make sure the zone is not bypassed.
•
Make sure you have not enabled the silent zone
funcon.
Steps
1.
Tap
Nocaon in the mobile client to enter the page.
51

HIKVISION AXHub Specifications

General

Brand	HIKVISION
Model	AXHub
Category	Control Panel
Language	English