HIKVISION AXHub User Manual

Click Partly Restore to restore all parameters except for admin
user informaon, wired network, Wi-Fi network, detector
informaon, and peripheral informaon to default ones.
Click Restore All to restore all parameters to the factory
sengs.
Import Conguraon File
Click View to select conguraon le from the PC and click
Import Conguraon File to import conguraon parameters
to the device.
Export Parameters
Click Export
Conguraon File to export the device
conguraon parameters to the PC.
Upgrade File
Click View to select an upgrade le from the PC and click
Upgrade to upgrade the device remotely.
Note
Do not power o when the device is upgrading.
Cercate Standard
Click System → System Maintenance → Cercate Standard to
enter the
cercate standard sengs page.
You can switch between EN Standard and General Standard
mode.
The device applies EN Standard by default.
Note
When you select EN Standard, the user permission and arming
parameters will conform to the EN Standard.
Local Log Search
You can search the log on the device.
Click System → Log to enter the Local Log Search page.
Figure 4-33 Local Log Search Page
Select a major type and a minor type from the drop-down list, set
the log start me and end me and click Filter. All ltered log
informaon will be displayed in the list.
You can also click Reset to reset all search
condions.
4.3.8 Check Status
Aer seng the zone, repeater, and other parameters, you can
view their status.
Click Status. You can view the status of zone, relay, siren, baery,
communicaon,
and repeater.
42

HIKVISION AXHub Specifications

General

Brand	HIKVISION
Model	AXHub
Category	Control Panel
Language	English