Figure 4-38 Zone Sengs Page
4.
Enable Zone Bypass and the zone will be in the bypass status.
The detector in the zone does not detect anything and you will
not receive any alarm from the zone.
4.4.9 Set Zone
Aer the detector is added, you can set the zone, including the
zone name, the zone type, zone bypass, linked camera, stay/away
status, the siren, and the silent zone. You can also view the
detector serial No. (only device in 433 HMz) and the detector
type of the zone.
Steps
1.
On the device list page, tap the security control panel and then
log in to the device (if required) to enter the control panel
page.
2.
Tap Zone and then tap a zone in the
Paron page to enter the
zone
sengs page.
48
To Next Page
Loading...
Need help?
General
