HIKVISION AXHub User Manual

Note
By default, the port number for EHome is 7660.
6.
Set an account, including the Device ID and Ehome Login
Password.
7.
Click Save.
NAT
Universal Plug and Play (UPnP™) is a networking architecture that
provides
compability among networking equipment, soware
and other hardware devices. The UPnP protocol allows devices to
connect seamlessly and to simplify the
implementaon of
networks in the home and corporate environments.
Enable the UPnP funcon, and you don’t need to congure the
port mapping for each port, and the device is connected to the
Wide Area Network via the router.
Steps
1.
Click
Communicaon Parameters → NAT to enter the page.
Figure 4-12 NAT Sengs
2.
Check the checkbox to enable UPnP.
3.
Oponal: Select the mapping type as Manual
4.
Set the HTTP port and the service port.
5.
Click Save to complete the
sengs
What to do next
Enter the tasks the user should do
aer nishing this task
(oponal).
4.3.2 Device Management
Zone
You can set the zone parameters on the zone page.
Steps
1.
Click Device Management → Zone to enter the Zone page.
23

HIKVISION AXHub Specifications

General

Brand	HIKVISION
Model	AXHub
Category	Control Panel
Language	English