HIKVISION DS-2TD6267-75C4L/WY - Set Manual Port Mapping; Multicast; Snmp

13.3.2 Set Manual Port Mapping
Steps
1.
Check Enable UPnP™, and choose a friendly name for the device, or you can use the default
name.
2.
Select the port mapping mode to Manual, and set the external port to be the same as the
internal port.
3.
Click Save.
What to do next
Go to the router port mapping
sengs interface and set the port number and IP address to be the
same as those on the device. For more
informaon, refer to the router user manual.
13.4
Mulcast
Mulcast is group communicaon where data transmission is addressed to a group of desnaon
devices simultaneously.
Go to
Conguraon → Network → Basic Sengs → Mulcast for the mulcast sengs.
For a device with more than one channel, mulcast can be set independently for each channel.
IP Address
It stands for the address of mulcast host.
Stream Type
The stream type as the
mulcast source.
Video Port
The video port of the selected stream.
Audio Port
The audio port of the selected stream.
13.5 SNMP
You can set the SNMP network management protocol to get the alarm event and excepon
messages in network transmission.
Before You Start
Before seng the SNMP, you should download the SNMP soware and manage to receive the
device
informaon via SNMP port.
Steps
1.
Go to the sengs page: Conguraon → Network → Advanced Sengs → SNMP .
2.
Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
89