HIKVISION DS-2TD6267-75C4L/WY - Set Fire Detection Parameters

16.7-1000
(focus
distance)
12.5-775
(focus
distance)
15.6-500
(focus
distance)
6.7-330 (focus
distance)
10-320
(focus
distance)
6-240 (focus
distance)
The le column is opcal rao, the right columns are speed level.
15
km
15 4 20 4 / / / / / / / /
10
km
10 5 15 4 12 4 / / / / / /
5 km 7 6 10 5 8 5 20 4 13 4 / /
3 to 5
km
5 6 7 6 6 6 13 4 9 5 15 4
4.5 Set Fire Detecon Parameters
To avoid the potenal re damage, you should congure the re detecon funcon for certain
areas. The detail
conguraon steps show as below.
Before You Start
●
The re detecon funcon can locate the re source area quickly together with patrol or linear
scan. Please refer to Set Patrol Scan for conguring patrol. Please refer to Set the Presets for
presets
seng.
●
Please refer to Set Device Posion for locang the re source posion.
●
Go to
Conguraon → Local , set the re point parameters.
Locate Highest Temperature Point
Click and save to show the posion of the highest temperature on the interface.
Frame Fire Point
Click and save to frame the detected re source.
Steps
1.
Go to Conguraon → Event → Smart Event , select Fire and Smoke Detecon.
2.
Check Enable Fire and Smoke
Detecon.
3.
Refer to Detecon Mode and Applicaon Scene for seng the re detecon mode.
4.
Check Display Fire Source Frame on Stream to display a red frame around the
re source on
stream when re occurs.
5.
Seng the parameters of re detecon.
Detecon Mode
by Single Frame
It can quickly detect
re while moving, but have a high false posive rate.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
18