HIKVISION DS-2TD6267-75C4L/WY - Set a Detection Scene; Set Ship Flow Detection

5.2.1 Set a Detecon Scene
Mulple detecon scenes are supported for both channels. You can create scenes and set the
tracking parameters for
beer target monitoring performance. The sengs may vary according to
dierent camera models.
Steps
1.
Go to Conguraon → Ship Detecon .
2.
Click Scene
Conguraon and New Scene to create one or more scenes.
3.
Select a numbered scene from the navigaon bar on the le and enter a Scene Name.
Note
If you want to show the name on the image, check Display Scene Name.
4.
Select a Channel No. from the drop down list.
5.
Set the Scene Rao by controlling the zoom in/out buons.
6.
Check Track to enable the target tracking funcon for the scene.
7.
Oponal: Check Limited Tracking and set the auto tracking range.
The camera channel tracks a target only within the set auto tracking range.
1) Control the PTZ buons to a desired scene and click Set Up Limit to save the posion as the
scene's upper boundary.
2) Repeat to set the
le, right and lower boundaries of the scene.
Tracking Duraon
Set the duraon of tracking. If the value is selected as 0, the tracking duraon will not be
limited.
Zooming
Rao
It is the zoomed-in level when the camera channel is tracking a target.
Go to Conguraon → Ship Detecon → Zooming Rao , select a scene from the drop-
down list, and control the zoom in/out
buons to get a desired zooming level, and save the
sengs.
Post-tracking
Set the duraon of automac tracking of the target aer it stops.
Go to
Conguraon → VCA → Advanced Conguraon , and set parameter.
8.
Click Save.
5.2.2 Set Ship Flow
Detecon
Aer enabling this funcon, the device will trigger an alarm if ships enter or exit the set regions,
and will count the ships that pass across the alarm line for the rst me.
Steps
1.
Go to Conguraon → Ship Detecon → Scene Conguraon → Scene x → Rule .
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
24