HIKVISION DS-2TD6267-75C4L/WY - Set Fishing Ship Detection; Set Capture Ratio

9.
Refer to Set Arming Schedule for seng scheduled me. Refer to Linkage Method Sengs for
seng linkage method.
5.2.4 Set Fishing Ship Detecon
Aer enabling this funon, the device will detect shing ships and trigger an alarm according to
the alarm sengs.
Steps
1.
Go to
Conguraon → Ship Detecon → Scene Conguraon → Scene x → Rule .
2.
Select Fishing Ship Detecon from the drop-down list.
3.
Set the min. size and the max. size of the target. When the target is smaller than the min. size or
bigger than the max. size, the device can detect the target, but no alarm will be triggered.
4.
Set the min. speed and the max. speed of the target. When the target speed is less than the min.
speed or greater than the max. speed, the device can detect the target, but no alarm will be
triggered.
5.
Click Draw Area. Click and drag the mouse in the live video window to draw the area. You can
drag the corners of the rectangle area to draw a polygon area.
6.
Oponal: Click Stop Drawing to nish drawing or click Clear All to clear all of the areas you set
without saving them.
7.
Click Save.
8.
Refer to
Set Arming Schedule for seng scheduled me. Refer to Linkage Method Sengs for
seng linkage method.
5.2.5 Set Capture
Rao
Aer enabling this funcon, ship-centered captures with the set capture rao will be uploaded
when a ship detecon alarm is triggered.
Steps
1.
Go to Conguraon → Ship Detecon → Scene Conguraon .
2.
Select a scene.
3.
Check Enable Center Capture.
4.
Set Capture
Rao and Centering Dwell Time.
Capture
Rao
Set the rao of the captured image by controlling the zoom in/out buons.
Centering Dwell Time
The duraon of the current status aer the center capture.
5.
Click Save.
Note
This funcon is invalid when the tracking funcon is enabled.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
26