HIKVISION DS-2TD6267-75C4L/WY - Set Video Tampering Alarm

Sensivity
The higher the value of sensivity is, the more sensive the moon detecon is. If the
sensivity is set to 0, moon detecon and dynamic analysis do not take eect.
3.
Select an Area and click Draw Area. Click and drag the mouse on the live video, then release the
mouse to nish drawing one area.
Figure 7-2 Set Rules
Stop Drawing Finish drawing one area.
Clear All Delete all the areas.
4.
Oponal: Repeat the above steps to set mulple areas.
7.2 Set Video Tampering Alarm
When the congured area is covered and cannot be monitored normally, the alarm is triggered and
the device takes certain alarm response acons.
Steps
1.
Go to Conguraon → Event → Basic Event → Video Tampering .
2.
Select the channel number.
3.
Check Enable.
4.
Set the
Sensivity. The higher the value is, the easier to detect the area covering.
5.
Click Draw Area and drag the mouse in the live view to draw the area.
Stop Drawing
Finish drawing.
Clear All Delete all the drawn areas.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
37