HIKVISION DS-2TD6267-75C4L/WY - Synchronize FOV; Set Transmission Parameters

10.1.16 Synchronize FOV
Click to synchronize the FOV of opcal lens and thermal lens.
10.2 Set Transmission Parameters
The live view image may be displayed abnormally according to the network condions. In dierent
network environments, you can adjust the transmission parameters to solve the problem.
Steps
1.
Go to Conguraon → Local .
2.
Set the transmission parameters as required.
Protocol
TCP
TCP ensures complete delivery of streaming data and
beer video quality, yet the real-me
transmission will be aected. It is suitable for the stable network environment.
UDP
UDP is suitable for the unstable network environment that does not demand high video
uency.
MULTICAST
MULTICAST is suitable for the
situaon that there are mulple clients. You should set the
mulcast address for them before selecon.
Note
For detailed informaon about mulcast, refer to Mulcast .
HTTP
HTTP is suitable for the situaon that the third-party needs to get the stream from the
device.
Play Performance
Shortest Delay
The device takes the
real-me video image as the priority over the video uency.
Balanced
The device ensures both the
real-me video image and the uency.
Fluent
The device takes the video
uency as the priority over teal-me. In poor network
environment, the device cannot ensures video uency even the uency is enabled.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
61