HIKVISION DS-2TD6267-75C4L/WY - Set SSH; Set HTTPS

Enable Cercate Expiraon Alarm
Steps
1.
Check Enable
Cercate Expiraon Alarm. If enabled, you will receive an email or the camera
links to the surveillance center that the cercate will expire soon, or is expired or abnormal.
2.
Set the Remind Me Before Expiraon (day), Alarm Frequency (day) and Detecon Time (hour).
Note
●
If you set the reminding day before expiraon to 1, then the camera will remind you the day
before the expiraon day. 1 to 30 days are available. Seven days is the default reminding days.
●
If you set the reminding day before expiraon to 1, and the detecon me to 10:00, and the
cercate will expire in 9:00 the next day, the camera will remind you in 10:00 the rst day.
3.
Click Save.
14.15.5 Set SSH
SSH is a protocol to ensure security of remote login. This seng is reserved for professional
maintenance personnel only.
Steps
1.
Go to
Conguraon → System → Security → Security Service .
2.
Check Enable SSH.
3.
Click Save.
14.15.6 Set HTTPS
HTTPS is a network protocol that enables encrypted transmission and identy authencaon,
which improves the security of remote access.
Steps
1.
Go to Conguraon → Network → Advanced Sengs → HTTPS .
2.
Check Enable .
3.
Oponal: Check HTTPS Browsing to access the device only via HTTPS protocol.
4.
Click Delete to recreate and install cercate.
Create and install self-signed
cercate Refer to
Create cercate request and install cercate Refer to
5.
Click Save.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
105