HIKVISION DS-2TD6267-75C4L/WY - Set Supplement Light

Night
The image is black/white or colorful and the supplement light will be enabled to ensure clear
live view image at night.
Auto
The camera switches between the day mode and the night mode according to the
illuminaon
automacally.
Scheduled-Switch
Set the Start Time and the End Time to
dene the duraon for day mode.
Note
●
Day/Night Switch funcon varies according to models.
●
You can turn on the smart supplement light in auto, night, and schedule-switch modes for beer
image eect.
11.5.6 Set Supplement Light
Steps
1.
Go to
Conguraon → Maintenance → System Service .
2.
Check Enable Supplement Light.
3.
Click Save.
Set Laser Parameters
You can enable the laser supplement and adjust the laser supplement angle to improve the image
eect.
Before You Start
Check Enable Supplement Light
rst before you congure this funcon.
Steps
1.
Go to
Conguraon → System → Maintenance → System Service .
2.
Select Laser Opcal Axis Adjustment from the drop-down list.
3.
Check Enable Laser
Opcal Axis Adjustment.
4.
Adjust the opcal zoom rao to the maximum value via PTZ control panel.
5.
Click the
direcon buons to adjust the posion of laser.
6.
Adjust the sensivity. The higher the value is , the faster the cursor moves.
7.
Click Save when the laser point is in the center of live view.
8.
Go to
Conguraon → Image → Display Sengs → Image Enhancement to set the laser
compensaon region.
9.
Adjust the level of laser
compensaon.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
71