HIKVISION DS-2TD6267-75C4L/WY - Lens Parameters Adjustment; Conduct 3 D Positioning; Icing

Note
The funcon is only supported by certain models.
10.1.13 Lens Parameters Adjustment
It is used to adjust the lens focus, zoom and iris.
Zoom
●
Click , and the lens zooms in.
●
Click
, and the lens zooms out.
Focus
●
Click
, then the lens focuses far and the distant object gets clear.
●
Click , then the lens focuses near and the nearby object gets clear.
PTZ Speed
●
Slide to adjust the speed of the pan/lt movement.
Iris
●
When the image is too dark, click to enlarge the iris.
●
When the image is too bright, click
to stop down the iris.
10.1.14 Conduct 3D
Posioning
3D posioning is to relocate the selected area to the image center.
Steps
1.
Click
to enable the funcon.
2.
Select a target area in live image.
-
Le click on a point on live image: the point is relocated to the center of the live image. With
no zooming in or out
eect.
-
Hold and drag the mouse to a lower right posion to frame an area on the live: the framed
area is zoomed in and relocated to the center of the live image.
-
Hold and drag the mouse to an upper le posion to frame an area on the live: the framed
area is zoomed out and relocated to the center of the live image.
3.
Click the
buon again to turn o the funcon.
10.1.15 De-icing
Click to perform manual de-Icing of the device.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
60