HIKVISION DS-2TD6267-75C4L/WY - Overlay Picture; Set Manual DPC (Defective Pixel Correction)

Text Overlay
Set customized overlay text on image.
OSD Parameters
Set OSD parameters, such as Display Mode, OSD Size, Font Color, and Alignment.
11.7 Overlay Picture
Overlay a customized picture on live view.
Before You Start
The picture to overlay has to be in BMP format with 24-bit, and the maximum picture size is 128 ×
128 pixel.
Steps
1.
Go to picture overlay
seng page: Conguraon → Image → Picture Overlay .
2.
Select a channel to overlay picture.
3.
Click Browse to select a picture, and click Upload.
The picture with a red rectangle will appear in live view
aer successfully uploading.
4.
Check Enable Picture Overlay.
5.
Drag the picture to adjust its
posion.
6.
Click Save.
11.8 Set Manual DPC
(Defecve Pixel Correcon)
If the amount of defecve pixels in the image is comparavely small and accurate correcon is
needed, you can correct these pixels manually.
Steps
1.
Go to Conguraon → Image → DPC .
2.
Select the thermal channel.
3.
Select manual mode.
4.
Click the
defecve pixel on the image, then a cursor shows on the live view.
5.
Click Up, Down, Le, Right to adjust the cursor posion to the defecve pixel posion.
6.
Click , then click to correct defecve pixel.
Note
If mulple defecve pixels need to be corrected, click aer locang a defecve pixel. Then
aer locang other pixels, click to correct them simultaneously.
7.
Oponal: Click to cancel defecve pixel correcon.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
77