HIKVISION DS-2TD6267-75C4L/WY - Set Expert Mode; Set Thermography Rule

Note
Go to Image → VCA Rules Display to adjust the font size and the temperature color of normal,
alarm and pre-alarm.
3.3.3 Set Expert Mode
Select the temperature measurement rules from Point, Line, or Area and congure parameters,
the device alarms if the alarm rules are met.
Steps
1.
Go to
Conguraon → Temperature Measurement → Basic Sengs , check Enable
Temperature Measurement.
2.
Refer to
Set Thermography Parameters to set the parameters.
3.
Go to Conguraon → Temperature Measurement → Advanced Sengs , select Expert.
4.
Refer to Set Preset to set a preset.
5.
Select and enable the temperature measurement rules. Please refer to
Set Thermography Rule
for seng the rule.
6.
Oponal: Click Area's Temperature Comparison to set the alarm rules and the temperature.
7.
Refer to Set Arming Schedule for seng scheduled me. Refer to Linkage Method Sengs for
seng linkage method.
8.
Click Save.
The maximum temperature and thermography rules will be displayed on the live view.
Note
Go to Image → VCA Rules Display to adjust the font size and the temperature color of normal,
alarm and pre-alarm.
9.
Oponal: Call the preset and check if the rules are ecient.
10.
Enable the scan funcon of device, such as linear scan to monitor the scene.
3.3.4 Set Thermography Rule
Steps
1.
Customize the rule name.
2.
Select the rule type to Point, Line, or Area. Then draw a point, line, or area on the interface
where the
posion to be measured.
Point
Please refer to Point Thermography for detailed conguraon.
Line Please refer to Line Thermography for detailed conguraon.
Area Please refer to Area Thermography for detailed conguraon.
3.
Congure the temperature measurement parameters.
Emissivity
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
10