HIKVISION DS-2TD6267-75C4L/WY - Set Manual Compass; Set Auto Compass; Set Power off Memory

The device uploads the alarm informaon when the alarm is triggered.
5.
Get the device locaon informaon in advance, and input the longitude and latude of the
device manually.
6.
Click Save.
What to do next
If you lost
direcon when operang the device, you can click Point to North to call the north
posion that is saved in the device.
9.12.1 Set Manual Compass
Use a direcon indicang device to determine the North at the device locaon, and set the North
for the device.
Before You Start
Use a
direcon indicang device to determine the north at the device locaon.
Steps
1.
Select the PT Mode as Manual.
2.
Adjust the
lt posion of the device to 0 by controlling the up arrow and down arrow on the PTZ
panel.
3.
Adjust the pan
posion to show the live view of the north direcon by controlling the le arrow
and right arrow on the PTZ panel.
4.
Click Set as North.
9.12.2 Set Auto Compass
For the device that has built-in e-compass, the compass can automacally tell the north direcon
for the device.
Before You Start
Electromagnec interference may aect the accuracy of the e-compass. Use manual compass if
electromagnec interference occurs in the device installaon environment.
Steps
1.
Select the PT Mode as Auto.
2.
Click Calibrate to synchronize the north of the device with that of the e-compass.
9.13 Set Power
O Memory
This funcon can resume the previous PTZ status of device aer it restarng from a power-o.
Steps
1.
Go to Conguraon → PTZ → Basic Sengs .
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
55