HIKVISION DS-2TD6267-75C4L/WY - Set up Hik-Connect

Before You Start
You need to acvate the camera before enabling the service.
Steps
1.
Access the camera via web browser.
2.
Enter
plaorm access conguraon interface. Conguraon → Network → Advanced Sengs
→ Plaorm Access
3.
Select Hik-Connect as the
Plaorm Access Mode.
4.
Check Enable.
5.
Click and read "Terms of Service" and "Privacy Policy" in pop-up window.
6.
Create a
vericaon code or change the old vericaon code for the camera.
Note
The vericaon code is required when you add the camera to Hik-Connect service.
7.
Save the sengs.
Enable Hik-Connect Service via SADP
Soware
This part introduce how to enable Hik-Connect service via SADP soware of an acvated camera.
Steps
1.
Run SADP soware.
2.
Select a camera and enter Modify Network Parameters page.
3.
Check Enable Hik-Connect.
4.
Create a
vericaon code or change the old vericaon code.
Note
The vericaon code is required when you add the camera to Hik-Connect service.
5.
Click and read "Terms of Service" and "Privacy Policy".
6.
Conrm the sengs.
13.8.2 Set Up Hik-Connect
Steps
1.
Get and install Hik-Connect
applicaon by vising hps://www.hikmicro.com/en/ . Then go to
Support → Download Center → Soware to down load the applicaon.
2.
Start the applicaon and register for a Hik-Connect user account.
3.
Log in aer registraon.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
92