HIKVISION DS-2TD6267-75C4L/WY - Set Scene Auto-Switch; Advanced Parameters

5.3 Set Scene Auto-Switch
The device supports patrol among the scenes and performs the set detecon. Patrol sequence and
dwelling me in each scene are congurable.
Before You Start
Finish scene sengs in advance. See Set a Detecon Scene for conguraon instrucons.
Steps
1.
Go to Ship
Detecon → Scene Auto-Switch to congure this funcon.
2.
Set the scene patrol sequence.
Scene Name
Select a scene name from the drop down list.
Dwell Time
Set the dwell
me of the scene when doing patrol tracking.
Overstaying Alarm Time
Set the overstaying alarm
me of the scene when doing patrol tracking.
3.
Click the up, down arrow to adjust the patrol sequence.
4.
Click Save.
5.4 Advanced Parameters
Go to Conguraon → Ship Detecon → Advanced Sengs and congure the parameters.
Detecon Parameters
Object
Detecon Threshold
The higher the value is set, the more easily the target will be detected.
Generaon Speed
The higher the value is set, the faster the target generaon speed will be.
Restore Parameters
Restore Default
Click Restore to restore the parameters to the default values.
Restart Algorithm Library
Click Restart to restart the Algorithm Library.
Note
The sengs vary according to dierent models.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
27