HIKVISION DS-2TD6267-75C4L/WY - Chapter 5 Ship Detection; Set Basic Parameters for Ship Detection; Set Detection Scene and Rule

Chapter 5 Ship Detecon
In this funcon, you can set parameters and alarm rules for ship ow detecon, dredger detecon,
and shing ship detecon. The camera will detect the target according to the sengs, and will
alarm when the target breaks the set rules. This funcon varies according to dierent camera
models.
5.1 Set Basic Parameters for Ship Detecon
Steps
1.
Go to
Conguraon → Ship Detecon .
2.
Go to Basic Parameter to congure ship detecon parameters for the device.
Enable Ship
Detecon
Select to enable the ship detecon funcon.
Display Ship Info on Stream
Select to display the ship
informaon on the stream.
Back to Scene Time
Set the me back to the detecon aer the detecon is interrupted manually.
Device Height
Set the installaon height of the device in actual applicaons. The installaon height is the
distance from the device to the water surface.
3.
Click Save.
5.2 Set
Detecon Scene and Rule
You can create one or more scenes, and set parameters and rules for each scene. The camera will
track the target and alarm when the rule is triggered.
Steps
1.
Go to
Conguraon → Ship Detecon → Scene Conguraon .
2.
Click Scene Conguraon and New Scene to create one or more scenes.
3.
Go to Scene x → Rule .
4.
Set rules for the selected
funcon mode.
●
Refer to
Set Ship Flow Detecon for seng rules for ship ow detecon.
●
Refer to Set Dredger Detecon for seng rules for dredger detecon.
●
Refer to
Set Fishing Ship Detecon for seng rules for shing ship detecon.
5.
Refer to Set Arming Schedule for seng scheduled me. Refer to Linkage Method Sengs for
seng linkage method.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
23