HIKVISION DS-2TD6267-75C4L/WY - Set Detection Scenes and Tracking; Set Rules

6.3.1 Set Detecon Scenes and Tracking
Mulple detecon scenes are supported for both channels. You can create scenes and set the
tracking parameters for
beer target monitoring performance.
Steps
1.
Go to Conguraon → VCA , and select a camera channel.
2.
Click Scene Conguraon and New Scene to create one or more scenes.
3.
Select a numbered scene from the
navigaon bar on the le and enter a Scene Name.
Note
If you want to show the name on the image, check Display Scene Name.
4.
Select the type of the scene.
Note
The congured rules in current scene will be cleared if you modify the type.
5.
Check Track to enable the target tracking funcon for the scene.
6.
Oponal: Check Limited Tracking and set the auto tracking range.
The camera channel tracks a target only within the set auto tracking range.
1) Control the PTZ
buons to a desired scene and click Set Up Limit to save the posion as the
scene's upper boundary.
2) Repeat to set the
le, right and lower boundaries of the scene.
7.
Set other tracking parameters.
Tracking
Duraon
Set the duraon of tracking. If the value is selected as 0, the tracking duraon will not be
limited.
Zooming Rao
It is the zoomed-in level when the camera channel is tracking a target.
Go to
Conguraon → VCA → Zooming Rao , select a scene from the drop-down list, and
control the zoom in/out buons to get a desired zooming level, and save the sengs.
Post-tracking
Set the duraon of automac tracking of the target aer it stops.
Go to
Conguraon → VCA → Advanced Conguraon , and set parameter.
8.
Click Save.
6.3.2 Set Rules
The device can detect whether there is any target breaking the VCA rules. The opcal camera will
track the target or the device will alarm when the VCA rule is triggered.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
30