HIKVISION DS-2TD6267-75C4L/WY - Set PTZ Priority

2.
Select Resume Time Point. When the device stays at one posion for the set resume me point
or more, the posion is saved as a memory point. The device returns to the last memory point
when it restarts.
3.
Click Save.
9.14 Set PTZ Priority
The
funcon can set the PTZ priority of dierent signals.
Steps
1.
Go to Conguraon → PTZ → Priorize PTZ .
2.
Set the priority signal and delayed
me.
Network
The network signal controls the device with priority.
RS-485
The RS-485 signal controls the device with priority.
Delay
It refers to the me interval of PTZ operaon controlled by dierent signals. When the
operaon with high priority is nished, the low priority signal controls the device aer the
seng interval.
3.
Click Save.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
56