HIKVISION DS-2TD6267-75C4L/WY - Set Linear Scan

Steps
Note
This funcon is only supported by certain models.
1.
Click to show the PTZ control panel, and click .
2.
Select one paern scan path that needs to be set.
3.
Click
to start recording paern scan.
4.
Click PTZ control buons as demands.
Note
Recording stops when the space for paern scan is 0%.
5.
Click to complete one paern scan path sengs.
6.
Click to call paern scan.
Stop paern scan.
Reset paern scan path.
Delete the selected paern scan.
Note
If you need to delete all the paern scans, go to Conguraon → PTZ → Clear Cong , and
check Clear All Paerns, and click Save.
9.5 Set Linear Scan
The device can perform auto scan in seng area for re source detecon.
Steps
1.
Go to
Conguraon → PTZ → Linear Scan .
2.
Select the camera channel.
3.
Zoom in and zoom out the camera to the appropriate zoom
rao, and click Save Rao.
Note
Click Enable Saved Rao to set the camera to the saved zoom rao.
4.
Check Enter Area Sengs.
5.
Set the le/right/up/down limits with the PTZ control panel, and click to conrm sengs.
6.
Oponal: Click Clear to delete the saved scan area.
7.
Click Save.
8.
Click Call Linear Scan to start linear scan, and click Stop Linear Scan to stop linear scan.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
50