HIKVISION DS-2TD6267-75C4L/WY - Page 32

Figure 4-2 Set the Presets for re detecon
2.
Divide the scan area into three parts and set a preset every 120°. The black numbers are presets,
and the red numbers are scan areas.
3.
Set the presets according to the sequence of patrol path: 1->2->3->1->4->5->6->4.
Note
●
When set the presets, you should adjust the zoom rao to view the image of both opcal
channel and thermal channel clearly.
●
The recommended zoom rao of opcal channel and patrol speed shows in the table below.
Thermal & Opcal Bi-spectrum PTZ Network Camera User Manual
17