HIKVISION DS-K1T341A Series

2. Click Add to open the Add window.
3. Select EHome as the adding mode.
4. Enter the required informaon.
Device Account
En
ter the account name registered on EHome protocol.
EHome Key
For EHome 5.0 devices, enter the EHome key if you have set it when conguring network
center parameter for the device.
Note
This funcon should be supported by the device.
5. Oponal: Check S
ynchronize Time to synchronize the device me with the PC running the client
aer adding the device to the client.
6. Oponal: Check Import to Group to create a group by the device name, and import all the
channels of the device to the group.
7. Finish adding the device.
-
Click Add to add the device and go back to the device list.
-
Click Add and New to save the sengs and connue to add other device.
Note
Face pictures cannot be applied to devices added by EHome account.
8. Oponal: P
erform the following operaon(s).
Device Status Click
on
Operaon column to view device status.
Edit Device
Informaon
Click
on Operaon column to edit the device informaon, such as
de
vice name, device account, and EHome key.
Check Online User Click
on Operaon column to check the online users who access
the de
vice, such as user name, user type, user's IP address, and login
me.
Refresh Click
on Operaon column to get the latest device informaon.
Delete Device Select one or mulple devices and click Dele
te to delete the selected
device(s) from the client.
Import Devices in a Batch
The devices can be added to the soware in a batch by entering the device informaon in the pre-
de
ned CSV le.
Steps
1. Enter the Device Management page
DS-K1T341A Series Face Recognion Terminal User Manual
95