HIKVISION DS-K1T341A Series

RS-485 Address
Set the RS-485 Address according to your actual needs.
Note
If you select Access Con
troller: If connect the device to a terminal via the RS-485 interface, set
the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address
according to the door No.
Baud Rate
The baud r
ate when the devices are communicang via the RS-485 protocol.
Set Wiegand Parameters
You can set the Wiegand transmission direcon.
Steps
Note
Some device models do not support this funcon. Refer to the actual products when conguraon.
1. Click Conguraon → Access Con
trol → Wiegand Sengs .
Figure 8-12 Wiegand Page
2. Check Wieg
and to enable the Wiegand funcon.
3. Set a transmission direcon.
Input
The de
vice can connect a Wiegand card reader.
Output
The can connect an external access controller. And the two devices will transmit the card No.
via Wiegand 26 or 34.
4. Click Save to save the sengs.
Note
If you change the peripheral, and aer you save the device parameters, the device will reboot
automacally.
DS-K1T341A Series Face Recognion Terminal User Manual
82