162
_____________________________________________________________________________________________
7.1 General Specification
______________________________________________________________________________________________
14. Comparator function (COMP)
Comparator function
setting and using
For the touch panel, GP-IB, and/or RS-232C, comparator settings can be
made and execution carried out for two parameters.
Upper and lower limit
value settings (LIM)
For ABS (absolute values) setting
Upper and lower limit values (HI, LO) are set.
For%(percentages)setting
Set a reference value (REF) and upper- and lower-limit values (HI, LO).
For Δ% (deviation percentages) setting
Set a reference value (REF) and upper- and lower-limit values (HI, LO).
The measurement values are displayed as deviations from the reference
value (Δ
%).
Comparator result
output (HI, IN, LO)
EXT I/O connector (HI, IN, LO, AND output of two parameters, INDEX,
EOM signal outputs, TRIG, LOCK, LOAD signal inputs, internal 5 V, GND
output, external power supply, GND input)
15. Scaling function
Test value compensation is possible by setting the compensation coefficients
a and b to the following equation.
[test value after compensation] = a [test value] + b
When the parameter is D or Q, calculate from compensation value for
θ
.
16. Magnification display
function
The test values and comparator decision results can be displayed in enlarged
form
17. Continuous test
function
Continuous testing of the conditions which have been saved
18. Display digits
The values 3, 4, and 5 can be set as the number of displayed digits. The
actual number of displayed digits, however, depends on the parameter used.
Parameter
Setting value
θ
,Q
Comparator Δ%
setting
D Others
5
Up to the second
decimal place
Up to the fifth
decimal place
Up to 5 digits
4
Up to the first
decimal place
Up to the fourth
decimal place
Up to 4 digits
3
No decimal place
Up to the third
decimal place
Up to 3 digits
19. Display-setting
function
A setting can be made to turn on/off the indications of the LCD display and
voltage/current monitors.
20. System reset
All of the settings will revert to the factory settings.
21. Key lock function
(KEY LOCK)
This disables the operation of keys on the panel, by means of either the
special-purpose switch or EXT I/O connector on the rear panel.
22. Panel save (SAVE)
and load (LOAD)
function
A maximum of 30 sets of complete measurement conditions can be saved
and recalled.
23. Beep sound setting
(BEEP)
There are settings corresponding to key input and to the comparator results.
24. Interfaces
Touch panel settings
9518-01 GP-IB INTERFACE or 9593-01 RS-232C INTERFACE options
can be selected (separate package)
EXT I/O connector (standard)
25. Temperature range
for use
0to40 (32 to 104 ), up to 80% relative humidity,
no condensation.
26. Temperature range
for storage
-10 to 55 (14 to 131 ), up to 80%RH, no condensation.
To Next Page
Loading...
