Industrial Batteries & Energy Storage
sales@regalelectro.com.au
After use, turn OFF the power.
Measurement Precautions
Observe the following to avoid electric shock and short circuits.
Do not measure voltages of 60V DC or higher.
Do not measure grounded voltages of more than 70V DC.
Do not measure alternating voltage.
Be sure to connect the test leads properly.
Wear rubber gloves or gloves of similar material during measurement.
When measuring batteries, always ensure sufficient ventilation. Sometimes sparks may
occur when the test leads are connected to batteries, which can ignite any accumulated
inflammable gases such as hydrogen.
Handling the Test Leads
For safety reasons, when taking measurements, only use the 9465-10 Pin Type
Lead provided with the instrument or the optional test leads.
To avoid breaking the test leads, do not bend or pull them.
The ends of the test leads are sharp. Be careful to avoid injury.
To avoid damaging the test lead, grasp the connector, not the cable, when
unplugging the test lead.
To Next Page
Loading...
