5. After receipt of the table of permissible values is complete, click [OK].
6. Editing configurations for each table.
Refer to Section 7.4.3 Preparing a New Table of Permissible Values.
Transfer takes approx. three seconds.
7.4.6 Transferring Tables of Permissible Values
Transferring tables of permissible values will over-write all tables of permissible values stored
on the instrument.
1. Click [Transfer] on the Edit Comparator Table dialog box.
The following dialog box will appear. Click [Yes] to transfer the data if desired.
If the data has not already been saved, the following dialog box will appear. Click [Yes] to
save the data if desired.
Tables of permissible value transfer will begin.
To Next Page
Loading...
