When ‘- - - -‘ is displayed, the auto-hold feature cannot be used.
The auto-hold function can be used when ‘OF’ is displayed on-screen.
When using the auto-memory feature together with this feature, measured values can
be saved automatically after holding them.
In order to judge whether the ‘OF’ display has resulted from mistaken range settings,
using the comparator as well, or setting the comparator buzzer to ‘WARN/FAIL’ is
recommended.
Releasing the Auto-hold Feature
Press the key several times to turn off the icon.
6.3 Auto-Memory Feature
This feature saves measured values to memory automatically, immediately after the values have
been held.
Configuring the Auto-memory Feature
Press the key to display the icon. At this point, the memory feature is in effect.
Use the keys to select the memory no. to which the data will be saved. When data has already
been saved to the memory no. selected, the icon will be displayed.
When using the auto-memory feature together with this feature, measured values can be
saved automatically after holding them. In order to judge whether the ‘OF’ display has resulted from
mistaken range settings, using the comparator as well, or setting the comparator buzzer to
‘WARN/FAIL’, is recommended.
Releasing the Auto-memory
Press the key several times to turn off the icon.
To Next Page
Loading...
