After the ‘Found New Hardware’ window appears, the [Found New Hardware Wizard] dialog
box will appear.
4. Following the instructions in the [Found New Hardware Wizard] dialog box, install the driver.
If after installing the driver you connect the instrument to the computer using a different USB
port, the ‘Found New Hardware’ window will appear again and the Found New Hardware Wizard will
start up. Use this wizard to install the driver again for this port.
7.4 Using the Software
7.4.1 Connecting the 3554 to a Computer
1. Turn on the power to the instrument.
After turning on the power, check the instrument’s remaining battery power.
If the remaining battery power is low, replace the batteries with new ones.
2. Connect the instrument to a computer using the included USB cable.
To Next Page
Loading...
