Industrial Batteries & Energy Storage
sales@regalelectro.com.au
Operating Precautions
Setting up the Instrument
Operating temperature and humidity:
0 to 40°C (32 to 104°F), 80%RH or less (non-condensating)
Accuracy guarantee for temperature and humidity:
23 ± 5°C (73 ± 9°F), 80%RH or less (non-condensating)
Avoid the following locations that could cause an accident or damage to the instrument:
Exposed to direct sunlight
Exposed to high temperature
Exposed to liquids
Exposed to high humidity or condensation
Exposed to high levels of particulate dust
In the presence of corrosive or explosive gases
Exposed to strong electromagnetic fields
Near electromagnetic radiators
Preliminary Checks
Before using the instrument the first time, verify that it operates normally to ensure that no damage
occurred during storage or shipping. If you find any damage, contact Regal Electro.
Before using the instrument, make sure that the insulation on the test leads is
undamaged and that no bare conductors are improperly exposed. Using the instrument in such
conditions could cause an electric shock, so contact Regal Electro for replacements.
Handling the Instrument
To avoid electric chock, do not remove the instrument’s case. The internal components of
the instrument carry high voltages and may become very hot during operation.
To avoid damage to the instrument, protect it from physical shock when transporting and
handling. Be especially careful to avoid physical shock from dropping.
To avoid corrosion from battery leakage and problems with battery operation,
remove the batteries from the instrument if it is to be stored for a long time.
To Next Page
Loading...
