Industrial Batteries & Energy Storage
sales@regalelectro.com.au
6.4 Auto-Power-Save Feature (APS)
The auto-power-save feature can be used to control the instrument’s power consumption. When
any of the following conditions has continued for approx. ten seconds with no keys pressed, power
to the instrument will be turned off automatically.
When the resistance value displayed is ‘- - - -‘
Hold (measurement stopped)
Conditions other than measurement conditions (each configuration screen, data reading
screen)
Conditions following completion of communication
‘APS’ will begin to flash one minute before the power turns off.
This feature is turned on under initial configuration conditions. When the auto-power-
save feature is unnecessary, such as when using the instrument continuously, turn this
feature off.
When the auto-power-save screen has been displayed unintentionally, then the
power on again. The instrument’s settings will be restored unchanged.
Turning the Auto-power-save Feature on and off
1. Press key to turn the power off.
2. While holding key down, press key.
This will display the auto-power-save configuration screen.
3. Using keys, select ‘OFF’.
To turn the auto-power-save feature on, select ‘On’.
4. Press key to save the settings.
This will finalise the configuration process and restart the
instrument.
When turning off the power without finalising the
configuration process, the changes to settings will not be
saved.
6.5 System Reset
These steps can be used to restore the instrument to its initial configuration conditions.
However, note that the following settings will not be deleted:
Date and time
To Next Page
Loading...
