Industrial Batteries & Energy Storage
sales@regalelectro.com.au
1. Turn off the power to the instrument and remove the test lead.
2. Open the battery compartment cover on the rear of the instrument.
3. Insert 8 batteries, taking care to use the proper polarities.
4. Replace the battery compartment cover.
2.3 Connecting the Test Lead
To avoid electric shock, be sure to connect the test leads properly.
For safety reasons, when taking measurements, only use the test lead provided
with the instrument.
The ends of the test leads are sharp. Be careful to avoid injury.
Connect the test lead to the instrument. Be sure to connect all four terminal: SOURCE (+ -) and
SENSE (+ -).
When using the optional 9460 Clip Type Lead with Temperature Sensor, connect the mini-plug to the
TEMP. SENSOR terminal.
To Next Page
Loading...
